新型暂堵酸化用自降解暂堵剂的制备及现场应用

针对传统暂堵酸化用暂堵剂颗粒耐酸性差、降解性差和除堵工艺复杂等问题，本研究通过水溶液自由基聚合法制备了一种新型的自降解暂堵剂CQZDJ。考察了单体加量、交联剂加量、引发剂加量对CQZDJ凝胶强度和降解性的影响；通过FT-IR、TGA、SEM对其结构进行表征；并对其降解机理进行了探讨；最后在长8区块的环平81-8实验井进行了现场实践。结果表明：CQZDJ凝胶强度及降解时间与单体加量、交联剂加量、引发剂加量成正比关系，且降解时间可控；降解性实验表明CQZDJ在(1%~10%)HCl溶液、水、（2%~10%）NaCl溶液中均可在4 d内完全降解，具备良好的降解性能，对地层伤害小；SEM照片显示CQZDJ的降解过程是从初始三维网状结构逐渐崩解为层状结构，最终降解为无规则线性小分子链的过程；暂堵后现场流压上升6.3 MPa，日产油由3.87 t/d增产至5.22 t/d，实现了储层的有效改造，增产效果显著。      

Cyclohexane‐1,3‐dione as a derivatizing agent for the analysis of aldehydes by micelar electrokinetic chromatography with diode array detection

Aldehydes are important compounds in a large number of samples, especially food and beverages. In this work, for the first time, cyclohexane‐1,3‐dione (CHD) was used as a derivatizing reagent aiming aldehyde (formaldehyde, acetaldehyde, propionaldehyde, and valeraldehyde) analysis by MEKC‐DAD. The optimized separation of the derivates was performed using a voltage program (+20 kV, 0–15 min.; +23 kV, 15–17 min.) at a temperature of 26°C, and using as the running buffer a mixture containing 100 mmol/L of sodium dodecyl sulfate and 29 mmol/L of sodium tetraborate at pH 9.2, with maximum absorbance at 260 nm. CHD was compared with two other derivatizing agents: 3‐methyl‐2‐benzothiazolinone hydrazone and phenylhydrazine‐4‐sulfonic acid. The CHD‐aldehyde derivatives were also characterized by LC‐MS. The calibration curves for all aldehydes had r² above 0.999 and LODs ranged from 0.01 to 0.7 mg/L. The optimized methodology was applied in sugar cane brandy (cachaça) samples successfully. CHD showed to be an alternative derivatization reagent due to its stability, aqueous solubility, high selectivity and sensitivity, reduced impurities, and simple preparation steps.     

FT-IR surface analysis of poly [(4-hydroxybenzoic)-ran-(2-hydroxy-6-naphthoic acid)] fiber – A short review

Instrumental techniques such as Fourier Transform Infrared Spectroscopy (FT-IR) constitute well-studied methodologies for polymer characterization, including polymeric fibers. However, a relatively short number of scientific publications involve the characterization of commercial Poly [(4-hydroxybenzoic)-ran-(2-hydroxy-6-naphthoic acid)] (Vectran™) fiber and its surface species. The majority of the published infrared studies uses the medium infrared region (MIR) associated to the Attenuated total reflection (ATR) method. In this scenario, this short review addresses the characteristics of Vectran™ fiber, sample depth data of each FT-IR spectrum mode, reflection and photo-acoustic spectroscopy (PAS), including near infrared (NIR) analysis. This paper addresses also researches on the characterization of Vectran™ by several FT-IR analysis conditions aiming to contribute to future studies. This brief review deals with methodologies developed in the last decade and published by several scientific research groups, emphasizing studies conducted in the last five years. A critical assessment and trends are also included.     

A facile and eco-friendly approach for preparation of microkeratin and nanokeratin by ultrasound-assisted enzymatic hydrolysis

Protein is one of the most abundant natural polymeric materials, but only a few studies on nanoproteins have been conducted. In this paper, a novel approach based on ultrasound-assisted enzymatic hydrolysis was employed for the preparation of microkeratin and nanokeratin from wool. The hydrolysis system included a solution containing enzyme (esperase) and reductant (L-cysteine) and treated ultrasonically to remove the scales and amorphous regions within wool. Results showed that the reaction was most effective at 50 °C and pH 7, when incubated for 3 h, followed by sonication for 6 h. The products included spindle-shaped microkeratin (4–7 μm in diameter and 70–120 μm in length) and cone-shaped nanokeratin (50–300 nm in diameter and less than 15 μm in length). Under ultrasonic-assisted conditions, the yields of microkeratin and nanokeratin increased significantly, while the treatment time decreased. Fourier transform infrared spectroscopy (FTIR) showed that the chemical structures of microkeratin and nanokeratin did not change, compared to that of wool. X-ray diffraction (XRD) analysis showed that the microkeratin was mainly composed of α-helical structure, while the β-sheet structure was more prevalent in nanokeratin. The presented method is facile and eco-friendly, thereby paving new pathways for the preparation of microkeratin and nanokeratin.     

Preparing molecularly imprinted nanoparticles of saponins via cooperative imprinting strategy

Saponin is an important class of natural products with various pharmacological activities. The selective separation of saponins is an essential step before further analysis. Molecular imprinting has been an effective strategy for preparing antibody mimics. However, a facile and efficient imprinting strategy for saponins is still lacking owing to their amphiphilic nature. Herein, we have prepared the saponins imprinted nanoparticles via cooperative imprinting strategy. This new strategy relies on the combination of various non‐covalent interactions (hydrophobic and hydrogen bonding) and covalent boronate affinity interactions. The obtained imprinted nanoparticles could rebind specific saponins from complex matrices with good selectivity, superb tolerance to interference, and fast binding equilibrium. This method was verified to be versatile and facile. Thus, this strategy could greatly facilitate the preparation of imprinted nanoparticles for the specific recognition of saponins.     

膜流动电位测试中Ag-AgCl电极的制备及稳定性研究

膜的动电特性研究中,往往采用流动电位方法。该方法中,Ag-Ag Cl测试电极的质量是影响测试准确性的关键要素。本文采用正交试验设计和方差分析,着重考察电解法制备Ag-Ag Cl电极过程中,电流强度(I)、氯化时间(t)、电解质溶液浓度(CHCl)、电极来源(n)、烘烤温度(T)、活化电极溶液浓度(CKCl)等因素对Ag-Ag Cl电极稳定性的影响。得到Ag-Ag Cl电极的最优制备参数为:电流密度3.0m A/cm2,氯化时间50min,盐酸浓度0.1mol·L-1,烘烤温度120℃,活化电极溶液(KCl)浓度0.001mol·L-1;最显著影响因素为电极来源,显著影响因素为氯化时间和烘烤温度。对最优条件组合下制备的AgAg Cl电极,进行了稳定性实验,结果表明:制备的电极具有较好的稳定性,24h内电极电位漂移量小于0.10mv,7天内电极电位漂移量小于0.2mv;在聚偏氟乙烯中空纤维超滤膜流动电位测试中,流动电位与流动压差具有良好的线性和可重复性,回归曲线R20.99,变化规律符合Helmholtz-Smoluehowski公式,可以较好满足膜的流动电位测试要求。     

Reversed‐phase vortex‐assisted liquid–liquid microextraction: A new sample preparation method for the determination of amygdalin in oil and kernel samples

A novel, simple, and rapid reversed‐phase vortex‐assisted liquid–liquid microextraction coupled with high‐performance liquid chromatography has been introduced for the extraction, clean‐up, and preconcentration of amygdalin in oil and kernel samples. In this technique, deionized water was used as the extracting solvent. Unlike the reversed‐phase dispersive liquid–liquid microextraction, dispersive solvent was eliminated in the proposed method. Various parameters that affected the extraction efficiency, such as extracting solvent volume and its pH, vortex, and centrifuging times were evaluated and optimized. The calibration curve shows good linearity (r² = 0.9955) and precision (RSD < 5.2%) in the range of 0.07–20 μg/mL. The limit of detection and limit of quantitation were 0.02 and 0.07 μg/mL, respectively. The recoveries were in the range of 96.0–102.0% with relative standard deviation values ranging from 4.0 to 5.1%. Unlike the conventional extraction methods for plant extracts, no evaporative and re‐solubilizing operations were needed in the proposed technique.     

Efficient extraction of proteins from recalcitrant plant tissue for subsequent analysis by two‐dimensional gel electrophoresis

Protein extraction for two‐dimensional electrophoresis from tissues of recalcitrant species is quite problematic and challenging due to the low protein content and high abundance of contaminants. Proteomics in Shorea robusta is scarcely conducted due to the lack of a suitable protein preparation procedure. To establish an effective protein extraction protocol suitable for two‐dimensional electrophoresis in Shorea robusta, four procedures (borate buffer/trichloroacetic acid extraction, organic solvent/trichloroacetic acid precipitation, sucrose/Tris/phenol, and organic solvent/phenol/sodium dodecyl sulfate) were evaluated. Following these, proteins were isolated from mature leaves and were analyzed for proteomics, and also for potential contaminants, widely reported to hinder proteomics. The borate buffer/trichloroacetic acid extraction had the lowest protein yield and did not result in any banding even in one‐dimensional electrophoresis. In contrast, organic solvent/phenol/sodium dodecyl sulfate extraction allowed the highest protein yield. Moreover, during proteomics, organic solvent/phenol/sodium dodecyl sulfate extracted protein resolved the maximum number (144) of spots. Further, when proteins were evaluated for contaminants, significant (77–95%) reductions in the nucleic acids, phenol, and sugars were discernible with refinement in extraction procedure. Accumulated data suggested that the organic solvent/phenol/sodium dodecyl sulfate extraction was the most effective protocol for protein isolation for proteomics of Shorea robusta and can be used for plants that have a similar set of contaminants.     

Determination of hexavalent chromium in traditional Chinese medicines by high‐performance liquid chromatography with inductively coupled plasma mass spectrometry

An analytical method that combined high‐performance liquid chromatography with inductively coupled plasma mass spectrometry has been developed for the determination of hexavalent chromium in traditional Chinese medicines. Hexavalent chromium was extracted using the alkaline solution. The parameters such as the concentration of alkaline and the extraction temperature have been optimized to minimize the interconversion between trivalent chromium and hexavalent chromium. The extracted hexavalent chromium was separated on a weak anion exchange column in isocratic mode, followed by inductively coupled plasma mass spectrometry determination. To obtain a better chromatographic resolution and sensitivity, 75 mM NH₄NO₃ at pH 7 was selected as the mobile phase. The linearity of the proposed method was investigated in the range of 0.2–5.0 μg L^?1 (r² = 0.9999) for hexavalent chromium. The limits of detection and quantitation are 0.1 and 0.3 μg L^?1, respectively. The developed method was successfully applied to the determination of hexavalent chromium in Chloriti lapis and Lumbricus with satisfactory recoveries of 95.8–112.8%.